Simple Webcam Lens Cover

prusaprinters

<p>This is a simple lens cover for a generic webcam that attaches by gripping the focus ring around the lens.</p><p>There are three versions:</p><p>Original: Designed to use a piece of scrap filament as the hinge pin</p><p>Thinner: Same as the original, but with a thinner cover</p><p>Snap Together: Same as the Thinner version, but does not need a hinge pin.</p><h3>Print Settings</h3><p><strong>Printer Brand:</strong></p><p>Creality</p><p><strong>Printer:&nbsp;</strong></p><p>CR-6 SE</p><p><strong>Rafts:</strong></p><p>No</p><p><strong>Supports:&nbsp;</strong></p><p>No</p><p><strong>Resolution:</strong></p><p>200</p><p><strong>Infill:&nbsp;</strong></p><p>20</p><p><strong>Filament:</strong> Inland PLA + Neon Green</p><p><br>&nbsp;</p><p><strong>Notes:</strong></p><p>&nbsp;</p><p>You can slightly resize the split ring by placing the fingers in boiling water for a few seconds, then either tightening or widening the gap.</p><p>Don't leave it in the boiling water for more than a few seconds!</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p><p>Category: Camera</p>