SimpleHuman Foam Dispener wall mount

thingiverse

Wall Mount for the Simplehuman Foam Dispenser. 2 holes in the back should accommodate for most available screws to attach this mount to the wall. The Dispenser will sit nicely in the mount without tipping over unless excessive pressure is used to knock it off it's base. However I found it stable enough for every day use (especially considering this is sensor activated and shouldn't be touched unless you are cleaning or refilling it anyways.) I felt that 20% was enough but you can go higher if you need it to be more robust. PLA held up nicely for me, no need for anything stronger. Print it with the base side down, no need for supprots.