(Simpler) Samsung Gear Live Watch Stand

thingiverse

I simply removed some complexities to make it cheaper to print while it's WIP. V2 is now up and uses around half as much filament yet shouldn't be any less stable/sturdy. Instructions 15% infill seems low, but if using Cura or even Slic3r's honeycomb infill, it's surprisingly enough. V1 was very sturdy, I've been using it for a few days now and I feel 100% confident putting my $200 watch on it. V2 uses half as much filament and includes a hole in the bottom to route your USB cable through, but it shouldn't be any less stable. Might want to move to 20% infill on V2 just to be safe.