Single E3D hot end holder for Geeetech Pro printer

thingiverse

This is my design for an E3D hotend holder for my Geeetech Pro printer. My requirements for the design were: 1) holds E3D rigidly 2) integrated hot end cooling fan 3) integrated part cooling fan I am using a CPAP hose to feed the part cooling nozzle. I have designed this so you can design your own adapter as it is a separate item that is glued in place. You could probable put blower right on it but that would add mass! The flange with the hole is to allow mounting of a ten pin aviation connector to facilitate easy swapping of heads. I use a regular extruder to do flexible filament prints. Print Settings Printer: Geeetech Pro Supports: No Resolution: .3 Infill: 30% Notes: included are snap off anti warp pads. works well for me. Post-Printing clean up the part with a knife. sand the interior of the E3D mounting hole until you get a nice fit. you will need m3 and m4 hardware for fan mounting, mounting to printer.