Single Print Seagate External Hard Drive Case

thingiverse

This a case for an external Seagate hard drive that prints in one piece. The internal dimensions are 128mm long x 82mm wide x 30mm tall which allows enough room to store the USB cable below the hard drive. The walls are 2.5mm thick. Supports are needed because the bottom of the base is slightly above the print bed when the lid is open, which is how it prints. After printing use a small flat head screwdriver or small knife to separate the lid from the bottom support material (See included image) by flexing the lid slightly. The lid can be slightly moved back and forth to separate the internal section of the hinge (As with most print-in-place hinges) or you may find it easier to use pliers to grasp the hinge inside the case to loosen the seal of the hinge.