Sirius XM Radio mount for car CD player

pinshape

Nothing special on printing. No supports or rafts needed for either. I printed at .2mm with 15% infill just to print it quick to see and it seems to be plenty strong enough. Adjust as you wish though. The only other thing I can thing of is you might want to print it in ABS to withstand the elements. About the files. There's two versions: (a) The XM Radio mount is closer to the CD player and may be good for you if you have the dash room or want to wedge it in there. The bottom of the XM radio mount is curved a little like the original mount was. (b) The XM Radio mount is farther away from the CD player and I went on and made the mount flat (took out the curved part of the mount). I didn't like using the supplied Sirius XM radio mount that goes into the air vents or any of the other supplied ways to mount it and I couldn't find anything already done that I liked so here's my try at an XM radio mount using the CD player. I don't see this being specific to any vehicle as long as you have a CD player that you don't use and why would you with a Sirius XM radio. Sorry had to be said lol. I have printed and used both versions and they both work good for mounting the XM radio using the CD player slot. For me specifically version (a) is a little tight because of the dash above the CD player on my 2003 Dodge Durango so I designed version (b). Version (a) may also be slanted more towards the driver which may be good or bad for you depending on whether you allow someone else to mess with your XM radio. Still pretty new at the designing/redesigning thing and I expect it's not perfect but hope you enjoy and find this useful.