SJCAM M10+ slim frame mount

thingiverse

I didn't like the waterproof case or the shell frame that came with my new SJCam M10+ action camera as they were too tall/bulky and I wanted the lowest profile mount that would fit into a GoPro quick release clip. This shell clears all the buttons, mic, ports and screen and features the std 2-tongue connection as used on most camera accessory clips. I designed this for the M10+, I assume it will also fit the M10, and M10 wifi, but I don't have any to test. DISCLAIMER: This will probably break and your camera will fall off and get lost. Do not use where this will happen. I am using mine inside my car so if it breaks it won't go anywhere that I can't find it. I do NOT recommend using this for moto cross/mountain biking/rafting/skiing/etc/etc. I take no responsibility for lost or broken cameras. :) V3 is 2mm thick walls but I wanted thinner so final ver is v4 with 1mm thin walls. Print Settings Rafts: Doesn't Matter Supports: No Notes: I printed mine at .3mm layers, 3 shells, infill 15% (but doesn't really matter if you have enough shells). The overhanging clip at the top prints OK without support and you can probably clean it up post printing anyway.