Sjopenna floor lamp clips

prusaprinters

<p>After 4 years rubber bands on my Sjopenna Lamp got stretched to a point that it was falling apart. I found <a href="https://www.thingiverse.com/thing:4546189">this model</a>, but it was for the table lamp, so I created a set of similar clips in Fusion 360.&nbsp;</p><p>To replace all rubber bands you'll need 16 short, 16 medium-short, 8 medium-long, and 8 long clips.</p><p>I printed them in PLA using a 0.4mm nozzle, 0.45mm line width, and 3 line wide walls. With these settings, there is no infill, only walls.</p>