Skadis Hook (Straight Line)

prusaprinters

<p>Print in PETG using standard PETG printing parameters or some other tough plastic like ASA. &nbsp;I used Inland PETG and printed with Prusa's generic PETG parameters and infill 50%. &nbsp;Part is thin, so infill 15% will be fine. &nbsp;But higher infill is desirable for heavier loads.</p><p>BE CAREFUL PULLING OFF BED. &nbsp;Adhesion is fine on smooth plates. &nbsp;No brim/raft required. &nbsp;Part is liable to break if pulled off plate without care.</p><p>I use this in my kitchen to hold spatulas, tongs, measuring cups, etc. &nbsp;This would be useful for holding wrench sets, screwdrivers, paint scrapers, etc. &nbsp;Anything really. &nbsp;It's good to have options when it comes to Ikea Skadis and other peg-board hardware.</p>