SKR 1.4 Turbo Case

thingiverse

Hi, This is the case for SKR 1.4 + SKR 1.4 Turbo it will fit a 40x40x20 or 40x40x10 fan, fan will be blowing directly on the drivers and under them so the cooling should be more than enough. You can hold the fan in place by screws but should fit in perfectly without the need of screws (But there are holes for them so just to be sure you can use them). It just has one main hole for cables and in the lid, there is a hole 20x10 so you can push true connector for display. There are two holes in the case for USB + SD card. You can hold the board to the case by a 4x M3 screws and the lid is held to the box itself by another 4x M3 screws. Maybe will keep on developing in future some holes for mounting it to the frame or somewhere. I have printed it using normal PLA. Update 2/10/2020 V2 Lid + Box Resized a USB hole + SD card hole a little bit because it was kinda difficult to access SD card or to put cable inside, changed fan position to be located on LID + added hole for power of the fan, added some holes to the bottom, added holes for stepper motor cables for bit more clear cable managment. What I am looking forward: Probably will make some universal holder to 2020 Alluminium frames with T-slot nuts and m3 screws. Maybe will adjust lid so you can mount Raspberry Pi + stepdown + relay module there we will see.