SKR Controller box model 3.3 for SKR 1.3/4 and Pi 3 on Lack Enclosure

thingiverse

Really want to use the HortaInc control box for my new SKR 1.4, but it needed some tweaks to fit my Lack enclosure, so remixed the "Universal XL" version, realized it was too big, then remixed the standard version without switch. XL: Removed the bits that stick out, removed some holes that won't be useful, added some cable cutouts, added some screw holes to secure it to the Lack on the top and left, and made the top and left panels 1mm thicker. Holes are 5.9mm to fit 3/4x10 screws I bought for another project. Standard (more changes here): Removed the bits that stick out, removed some holes that won't be useful, added some cable cutouts, added some screw holes to secure it to the Lack on the top, sunk the outer side of the cable/zip tie cutouts 1mm in so they won't interfere with the Lack, and cutout to add/remove wifi module once board is installed. Holes are 5.9mm to fit 3/4x10 screws I bought for another project. You need to fit the motherboard, divers and the driver duct before attaching to the Lack, due to the way the driver duct is secured by a screw that will not be accessible once installed - hopefully someone will remix this problem away, but I made do, though installation was a bit fiddly. .step and .f3d included in case you want to continue this remix, or apply some of the same changes to the other models in the original. You can find the SKR 1.4 model (used to work out where the cutouts go) on the Bigtreetech github. Once all the cables are secured and everything is working, I plan on covering the cable cutouts on the rear with some masking tape, just to help airflow come in from the lower part of the case.