Skyrim DragonSkull Halved

thingiverse

edit2 since no one reads this, I'm just going to see about pulling this model. it look terrible, and it's dumb luck that some people have managed to print it. Go download this one instead. Much nicer: https://www.thingiverse.com/thing:2191651 edit I am calling this a failed print. There is just too much to cleanup on the part. I halved the Dragon skull and resized it to fit the bed of a Micro3d. I also added a 7mm (~1/4in) hold for a magnet at the base of the skull. This was mostly just a test part for learning how to cut up a model to fit the Micro3d's tiny print bed. I recommend printing it with supports, but I'll admit that the test print is 30 minutes into a 9 hour print at time of posting this. Changes I might make: I wish I had thrown this into Meshmixer to hollow out before I halved it. Also, It might have been a good idea to add a ball socket so this could be popped onto an action figure of some kind. Also, I think if this turns out well I'll try a T-Rex skull, and look for a skeleton body to go with it. Print Settings Printer: Micro3d Rafts: Yes Supports: Yes Resolution: user preference Infill: user preference