Skywalker X1 2204 Motor Mount

thingiverse

Many people run 1806 motors on their Skywalker X1 mini wings but I wished to use a slightly more powerful 2204 motor. The motor hole location is different with the 2204 than the 1806 hence this remix. I also increased the centre hole so it has better clearance from the larger 2204 shaft bearing & circlip & provided countersink wholes for M3 allen head bolts. I have tested this with an EMAX 2204 motor & it fits perfectly, The 2mm holes that attached it to the wood motor mount of the X1 remain unchanged but due to the increased thickness of the mount ( now 5mm due to countersink hole) I would say 10mm x 2mm screws would be needed. However screwing in these 2mm screws i think would be difficult as there is not much space with the motor installed to get your screwdriver in. Personally I will be fitting the motor to this print & then using Epoxy to glue this to the wooden plate on the X1. If i need to change the motor (unlikely) then I should be able to prise it off. Print Settings Rafts: No Supports: No Resolution: 0.2 Infill: 80 Notes: I printed this at 80% for strength but I would say 40% would be fine