Skywatcher EQ 3-2 Eyepiece Rack

thingiverse

This is a rack to hold 1.25 inch telescope eyepiece`s that fits into the metal tray that lives under the EQ3-2 telescope mount. Print Settings Printer: ctc rep dual sailfished Rafts: No Supports: Doesn't Matter Resolution: 0.20 / 0.25 Infill: 15 - 25 % Notes: Use 2 shells and 15% infill or 1 shell and 25% or anything you normally print at. 2 print runs are needed to make the full rack. 1 half of the rack and 1 locking pin are printed in each print run. They are interlocking so will require glue / bonding together. I made the interlocking parts with a bit of wiggle room for the bots that do not print to tight specs so should hold reasonably tight. I have not printed this later revision of the rack because i already have 2 printed up and each after each print i discoverd tiny problems that i needed to change. I made these changes and settled upon this version as the final design. I have one printed in abs and one in pla. my preference would be pla here but as its used outside and sometimes in damp / dew areas then abs would prob be better but its all up to the print master and their preferences. If anyone prints this and finds any problems , let me know and i will try and fix them for anyone else that wants to print the eyepeice holder.