SLA printer piggy bank

prusaprinters

<p>This is simple piggy bank in the shape of a SLA printer.</p><h3>Required hardware:</h3><ul><li>2 x M3 nuts</li><li>2 x M3 bolts (minimum length 16 mm)</li></ul><h3>Instructions:</h3><p>Print both parts: the standard SPEED profile works well enough. Print the top part with the closed side down to prevent support/bridging.&nbsp;</p><p>I can recommend orange and black, but a translucent filament may also work nicely for the top part! Additionally I can recommend the use of a textured build plate to give some texture to the top and bottom of the piggy bank.</p><p>Put top on bottom and insert the nuts in the slots. Then screw in the bolts via the side.</p><p><strong>Note:</strong> the model does not fully flip open (as seen in the third picture): the thinner black piece of the back hits the top.</p><p>Dimensions (W x L x H): 75 mm x 75 mm x 150 mm</p>