Sledgefire 17/32 Brass Barrel - Single Half Dart Hand Cannon

prusaprinters

<p>Shell: Converts the Nerf Sledgefire to fire 1 half-length dart through a 17/32 brass barrel. Deactivates the air restrictors well enough without needing removal. The brass barrel must be epoxied into place inside the printed shell. I also added a small amount of epoxy to the shell part where the supports once were. - See photos</p><p>** Print as imported with supports touching build plate enabled.</p><p>A better seal between the plunger and shell will be needed in order to not leak air. It is also essential to remove the shell ejector so that this part stays in place. The last two photos are the parts of the ejector that must be removed. Note: retain small spring and L shaped tooth and replace exactly as they were. This will prevent the shell from becoming misaligned or falling backwards during operation.</p><p>Void Fill: &nbsp;Fills the area where the Sledgefire stock once was. Drop in replacement. See photo.</p><p>**Print as imported with supports.</p><p>Front: Friction fits into the front end of the Sledgefire. Keeps the Brass barrel aligned nicely. This part has been updated to accommodate a barrel that tapers into a 9/16 brass tube. See photo.</p><p>**Print as imported without supports.</p><p>During testing I found this shell to hit an average of 118 FPS using Adventure Force Pro darts. Some over-sized Worker Gen3+ darts experience reduced performance. I found this mod to perform better with a small length of 17/32 barrel that tapers into 9/16 brass; especially in places with high humidity.&nbsp;</p><h3>&nbsp;</h3>