Sliding Rail Mount System for a spice rack

thingiverse

I made these raised slide rails for a vertically mounted slide-out spice rack. The rack came with short rails that didn't fit my kitchen cabinets. I could have just made spacers, but decided to redesign the whole slide rail mounting system. I include the scad so you can customize it any way you want. The important bits are adjustable such as length, base height, rail height, gap, etc. Instructions I included two rails at a time, side-by-side in the stl to avoid ABS lifting/warping. If you want a different configuration, scroll to the bottom of the scad. Each rail is wrapped up in the module called "final". I printed 3 sets for a total of two 10" long rails. (top and bottom mounts) The overhang for the rail capture is only at 15 degrees. It prints fine for me because it's only a few lines, but if your printer isn't up to it. You might want to increase the angle to 45.