Slinky_V17

prusaprinters

<p>Slinky with diameter of 90mm and height of 100mm and 50 rings. It is very nice, problem is just to separate the rings. Printed with PRUSAMENT. I try also other material, but didnt go well. Try a height of 10mm (Model for height 10mm is also in the attachments ) and try to separate the rings and then you are ready to print a height of 100mm.&nbsp;</p><p>Between rings is just 0,25mm of air. Hard to separate but nice to look.&nbsp;</p><p>Separation: First use Needle-noise pliers and with movement make place between two rings where you insert Olfa-knife and go with the knife over whole length.&nbsp;</p><p>Probably slinky should walk down the stairs, but the stairs were not found yet:) I would say the maximal length of the Stair should be cca 150mm.&nbsp;</p><figure class="media"><oembed url="https://www.youtube.com/watch?v=9IojLxKbob4"></oembed></figure><figure class="media"><oembed url="https://www.youtube.com/watch?v=Ba2qAZi-ZqI"></oembed></figure>