Small Clamp Easyprint

thingiverse

This is a remix of <a href = "https://www.thingiverse.com/thing:2040344">Small Clamp</a> by <a href="https://www.thingiverse.com/walter/about">walter</a>. Model was modified to be easy to print and assemble as there was a lot of trouble to print the whole clamp in one piece. Required materials: - M5 Screw - approximately 35mm long. - 2 x M3 Flathead Screw - 12mm or shorter. After printing and removing support you have to screw in the M3 screw inside the outer part's hole (that is used to put all wear and tear on it instead of pla/abs/whatever). Then you have to put the barrel through the outside and inside parts and screw down the barrel's top cover with the second M3 screw. Finally you have to screw in the last M5 screw in the inside part`s hole to be used as a lever. Congrats, you are done!