Small Dice Organiser / Rolling Tray - Easy Print and Glue

thingiverse

Remix of the fantastic Dice Tray by JimSaylor95. https://www.thingiverse.com/thing:2371070 Sliced the detail from the top and bottom of the main sections to allow for easier printing. Simply superglue the cutouts onto the main prints. Removes the need for supports. Takes a long time to print, but comes out amazingly well on a CR10-S on fine detail. The base detail overlay file prints pretty thin ... so would suggest printing at least this file at high detail to make more effective. Remove with care from the print bed. EDIT: The Internal Lid is the original - Therefore print this with supports it's not too bad. Put the honeycomb side down on the bed. If wanted I could slice this also Added 2 overhangs for the top lid. You could just do 1 twice ... but I added it anyway Edit: Be wary if using superglue to stick the base cover on, as it's very thin and superglue shows underneath it. Therefore if using a light colour glue carefully. Darker colours should have no issues. Mine was for painting so not an issue :) Have fun ....