Small Modular Parts Storage (for Totem Maker)

prusaprinters

<p>A set of small modular drawers that I use to store the many parts in the Totem Maker and Totem Robotics System. Note that there are <i>very</i> tight tolerances on how the drawers interlock! If you print in Prusament PLA on a Prusa Mini, then you should get a good result. Otherwise, you should start by printing the “TestSlotsSLICED” object and adjust your printer setting until you get a good fit.&nbsp;</p><p>I came to design this because I needed some storage for the many parts in the Totem Maker and Totem Robotics Kit. Totem Maker is a a set of ABS beams, plates, nuts, bolts and brackets that allows you to build almost anything you can imagine (www.totemmaker.net). The Totem Robotics Kit is a set of 7 remote controlled robots that you build based on Totem Maker components. There are about 40 different nuts, bolts, brackets and 3D printed components that all have to be stored somewhere. I originally used bead boxes, but found these too difficult to open. The sliding drawers offered by this system are much easier on the fingers.</p>