Small parts cabinet

thingiverse

This is a remix of the Fast-Printing Modular Drawer System by LR3DUK https://www.thingiverse.com/thing:5210727. I was intrigued by the use of the "vase/sprial" mode to print these parts and want to thank this designer for bringing this to my attention. I wanted to try out this mode and couldn't resist modifing the original design. I primarily use PETG filament and struggle to get the retraction settings right to avoid stringing. Using the "spiral" mode avoids retractions and thus makes very nice prints, although, with walls that are a bit "flimsy". The new design makes a slightly more compact cabinet with slightly larger drawers and more divider options. With fairly tight tolerances, close attention to the wall thickness is necessary for a nice fit. Using Cura slicer, I set the wall thickness to 0.8mm. With my printer and PETG filament, I had to set the "Flow" setting to 110% and only achieved a thickness of 0.72mm. I used the test cabinet to check for a good fit prior to the actual build. If you adjust the wall thickness setting to achieve a 0.7mm wall thickness everything should fit fine.