Smartphone Deskstand v3 - Quick and Easy Printable

thingiverse

This is a quick new desin of a smartphone deskstand (fits my xperia z3 which is quite large). Won´t tip over when you touch the display but it will slide back depending on the surface. Charging from the bottom will not be possible. But it is a very easy and fast (aprox. 1:10h) print - it is sturdy, functional and not round (compared to my other designs: http://www.thingiverse.com/thing:1806552 & http://www.thingiverse.com/thing:1783994 & http://www.thingiverse.com/thing:2037281). The design took me about an hour total (I reworked and adjusted the slots so this will be a tight and good fit without the need for glue or acetone). The "set.stl" contains all parts you need to print - but both sidepieces (called "arm2.stl") will be printed in the same orientation - therefore both surfaces which were on the buildplate will be facing in the same direction on the assembly - if you want it more symmetrical you need to flip 1 arm around before printing. I like the minimalist and functional design (of course i need to like it cause I made it^^) and the fact that the phone sits very close to the surface which will allow to place it in front of the monitor and not having the phone covering up the screen (if your screen is lifted off the table of course but most of them are). The material is yellow (obvious) Sakata Ingeo 3D850 (which I guess is only available in europe currently - I´m sorry). The layer adhesion is really amazing and it sticks very good to PEI but is also easily removeable. No odor and the colors are really really cool and solid. If interested where to buy it - drop my a message. Print Settings Printer: Prusa i3 mk2 Rafts: No Supports: No Resolution: 200 micron Infill: 25% Notes: This should be printable by nearly every printer and should fit together pretty easily.