Snapmaker 2.0 3D Printhead Bowden Tube fitting Adapter Plate

thingiverse

I made this Bowden Tube fitting adapter for the Snapmaker 2.0 because I came across a design https://www.thingiverse.com/thing:4628630 and printed and the mounting holes were quite far off and trying to make it work would of required either elongating the holes or end up cross-threading the holes in the body of my printhead. Also, I noticed that the baseplate was very thin and the design didn't account for the chamfer in the countersunk screws and there was a lot of wasted thread length sticking through the holes (with just one screw in for testing). This design accounts for all of the above and fits the Snapmaker 2.0 perfectly with tight tolerances where needed. This also is the maximum thickness to allow for a more robust part as some had commented in the above mentioned design where it snapped off because of the tension on the tube when printhead jogged right. My design should not break as easily and do recommend printing with 100% infill (totally solid) and with 2.0mm wall thickness as this allows for a much more structurally sturdy part. Also, please note that the "V1" part that is shown was a test fit after I printed the part and I just have white filament directly into the tubing fitting without actually having the normal tubing installed. I have a link to the Bowden tubing and fitting set below. I hope that this helps someone as it helped me. UPDATE!!! - I made a "V2" Bowden fitting plate design for the 3D Printhead as I wanted to reduce the height of the assembly to give more clearance, less material, and faster print time for this part. I also didn't like the cut in between the top threaded area and the base plate where it was difficult to get the head screws to go into the holes. This should also be able to take an insane amount of side pressure (much more than it would take to cause damage to the printhead or linear rail. https://www.amazon.com/gp/product/B07PV8754Z/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1