Snapmaker 2.0 Custom Roller Setup

thingiverse

Left and Right side Roller mounts for setting up a custom rotating engraving system for the SnapMaker 2.0 Once parts are assembled and attached to the printer you need to loosen the bolts on the rails and press down slightly on the printed brackets and retighten the bolts. This will create a slight amount of pressure on the rollers so that they roll as the bed moves. That is the reason for the slotted holes in the brackets. Amazon Parts: 1 Set of Rubber O-rings: 45mm OD 35mm ID 5mm Width https://www.amazon.com/gp/product/B07DG6CW6R/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 1 Set Linear Rail rod supports: 8mm Diameter Shaft https://www.amazon.com/gp/product/B07QS7Z8MK/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1 1 Set of linear rail rods: Diameter 8mm, 400mm Long https://www.amazon.com/gp/product/B087GJP5QM/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1 2 Sets of U-Groove pully bearings: 8mm Shaft Hole, 45mm Diameter, 11.5mm Width https://www.amazon.com/gp/product/B07D8RP4KZ/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1