Snapmaker Artisan double extrusion module front cover

thingiverse

Snapmaker Artisan双挤出模块因设计原因，喉管冷却的两个涡轮风机从喷嘴下方进风，这就不可避免地将打印过程中产生的飞丝及絮状物吸附在喷嘴及隔热套上，中途偶尔会掉落影响成品质量及观瞻，将前盖打开运行可改善这一状况，自己打印一个前盖代替官方的盖子吧，只需花1至3小时及不到40克的灯丝，无损替换！后侧两个6mm的圆孔是用方便易购的磁铁塞入，不装也没事，更换时只需用随机配送的灰色H1.5内六角扳手拧松上盖左侧的两个小螺丝，稍往上抬上盖，就可以取下前盖，然后装上新打印的前盖，拧紧螺丝即可。 ———————————————————————————— Below is a machine translation from Microsoft Snapmaker Artisan double extrusion module due to the design reasons, the two turbine fans cooled by the hose are fed from under the nozzle, which inevitably adsorbs the flying filaments and flocculent generated during the printing process on the nozzle and the heat insulation sleeve, and occasionally drop in the middle to affect the quality and view of the finished product, the front cover can be opened to improve this situation, print a front cover instead of the official cover yourself, it only takes 1 to 3 hours and less than 40 grams of filament, lossless replacement! The two 6mm round holes on the back side are stuffed with a convenient and easy-to-buy magnet, and it is okay if you do not install it, when replacing, you only need to use the randomly delivered gray H1.5 Allen wrench to loosen the two small screws on the left side of the upper cover, lift the upper cover slightly, you can remove the front cover, and then install the newly printed front cover and tighten the screws.