Snowboard Wall Mount, Adjustable ("Exhibit A")

myminifactory

Watch the Demo Build here: https://youtu.be/WGEDDWCxds0 Use this snowboard fixture to display your board in the vertical position, nearly flat against the wall, bindings out. Both screws mount into the same stud in the wall, spaced vertically, no drywall anchors. No measuring how far apart to hang two rubber stoppers, the width is adjustable and these Stoppers pivot to fit your boards edge angle. Adjust the width then lock the arms down by inserting the Locking Plate between them and fastening it down with screws. The Locking Plate positively locks the arms into position, it's not a friction hold. Is this overengineered? Maybe.   HARDWARE: (Five) #8-32 hex jam nuts (1/8" thick x 11/32 across flats   https://www.mcmaster.com/90480A009/ (Three) #8-32 Button Head Socket Cap Screws x 5/8" Long  https://www.mcmaster.com/92949A196/ (Two) #8-32 Button Head Socket Head Cap Screws x 1" Long   https://www.mcmaster.com/92949A199/ (Two) #10 Dry wall or wood panel screws, 2" Long (minimum), with 82° head. Https://www.mcmaster.com/90294A301/ Use stainless steel fasteners if you want to avoid corrosion from ice thawing, but I like the look of the Black Oxide steel fasteners because the heads blend in with the black print color.  HEX NUT POCKETS: You have to press the nuts into the hex shaped pockets on the printed parts. If the hex nuts you use are 1/8" thick, and the width across flats is .337-.346, it will work just fine.  The heads of the button head screws sit below the surface so they will not contact your beautiful board graphic ... unless you're a dink and you fail to fully seat the screws or you use the wrong screws. Don't be a dink, do it right.  Mount your snowboard and post a photo so I can revel in the beauty of it too.  Cheers, Mark