Soap dish “bubbles”

**An elegant soap dish with drainage in the style of my bubbles series.**
Single and multi-color printing models are included as STL and 3MF! They work with all current and usual multi color setups.

Cleaning: Empty out the drain when it is full. I advise to clean the product (as you should do with every soap dish) a few times a year. Best results are achieved with a regular old toothbrush. Scrub it for a minute or two under running warm water.

Size assembled ca: 105 x 105 x 15 mm
Photos by Maison Lumiere

**Print settings**
Required build volume: 110 x 110 x 20 mm
Material usage: 45g in total
Print time: 4-5 h in total

Material: PLA
Print direction: stls are rotated correctly, check images
Support: none
Nozzle size: 0,4 mm
Line width: 0,4 mm
Layer height 0,2 mm
Outer walls: 3
Infill: 20%
Build plate adhesion type: none

Watertight printing - If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.