Solar Energy Tracking System "OSADO TECHNOLOGY".

cults3d

Solar power tracker system created from scratch by Osado Technology. Its operation is given by averaging between the set of 4 LDRs conditioned by a voltage divider with a 10k resistor for each LDR. This system is made up of three parts, The base, The servo motor system and the support for the solar panel and LDRs. Inside the downloadable folder we will also find its respective program, it is applicable with both Arduino Mega and Uno. RECOMMENDATIONS. For the base it is recommended to use a MG90 servo motor and for the me motion system we can use SG90 or MG90 servo motors. To Join the motion system with the LDRs support and solar panel, two coin-shaped neodymium magnets should be used. To join the Main part 2 and 3, a recycled shaft from a disk drive can be used, the same to join the Main part 1 and 2. To attach the servo motors to the motion system, we can use any type of wire that is strong enough. To connect the main part 2 and 3 with the servomotors, we can use the same wire making a small hook, so we can join the wires coming from the servomotor The panel size for this system is 69 mm x 99 mm, but it can be adapted for any size. An LM35 temperature sensor can also be adapted to this system. In the pictures are the connection of the LDRs to the analog ports of Arduino.