Solar Filter Lens Hood (V2) for Canon 100-400mm (77mm diameter)

thingiverse

Updates: * Aug-10 2017: 2.0 update. Was not happy with uneven clamping. Increased clamping screws to 6, decrease mounting screws to 2. Tweaked front cap to maybe print better in ABS. * Aug-9 2017: Added a notch to outside of rings and inside of hood to ensure alignment. Made some screw holes bigger for ease of assembly. Added a front cover (currently un-tested). This is a redesign of my first version I posted a week or two ago. After being un-impressed with the cheap solar filter film I got on Amazon I ordered a sheet of BAADER solar film. When it arrived I found it to be much much thinner than the other film, similar to tissue paper. I knew that my last design would not hold onto this material, nor hold it taut. Thus the redesign. I will look into designed a front cover for this in the coming weeks. Materials needed: 2X M3x12(or 14) screw. 6X M3x8(6 might work) flat head screw (flat head not required, just looks better). I designed this so you're able to align your film onto a holding ring, and then install that ring inside the lens hood. I highly recommend you TEST this out on something cheap and similar to your solar film. If using the Baader film I'd recommend using a mylar "emergency blanket" as a test material to get the feel of installing a film. You want the film to tight, but NOT STRETCHED. Stretching a solar film can lead to degradation of it's filtering properties. This could cause blindness, and damage your camera! [This is where I ordered my solar filter film.](https://astro-physics.com/as50a4) [This was my original design. Still may be useful for thicker solar films.](https://www.thingiverse.com/thing:2435107)