Solarium Part, test your support settings.

thingiverse

This is a replacement part that was broken on a solar room cover. I posted it to show how my support settings are working. Since most of the object is actually flat in the air, almost the entire object is on support. IT WORKS GREAT. When you are finished printing, the raft support just pulls right off with an accordian effect. Since I had not seen this, I posted the gcode and my raft/support settings. This was printed without a raft. Instructions you may want to scale this down, as it uses a lot of plastic. But if you want to try my support settings, you will see its great.