Solder paste syringe dispenser

thingiverse

Solder paste syringe dispenser, based on a design I found on the internet https://www.youmagine.com/designs/manual-solder-paste-dispenser I altered the design so that it is easier to print and assemble. YOU NEED: 1 x M5 nut 1 x M5 threaded bar - around 100mm in length 1 x M4 nut (nylock type is best to stop it undoing) 1 x M4 x 35mm bolt or screw Assembly is straightforward, as per the pictures. Squeeze the handle to dispense solder paste, release and screw in the M5 threaded bar a little and then squeeze again, you will get the gist or understand after assembly. All credit goes to the original designer. There are two holders and plungers - one for 5cc syringes and one for 10cc syringes, just print the one that you need. Print one handle and one clasp .