Solder Spool Axle

prusaprinters

<p>I have an off brand Chinese hot air/solder station (a Hakko knockoff from Circuit Specialists). While putting up a shelf, I broke the axle of the solder spool. Although I could have glued the center back together, one of the end caps just went missing so I made some measurements and just printed a new one.</p> <h3>Instructions</h3> <p>Print all three pieces. If your bottom is "squishy" you may have to open the bottom part of the tube out with a hobby knife. If you get carried away (don't ask how I know) a little glue will save the day. But if your printer is lined up right the top part should just pressure fit with one of the caps.</p> <p>The picture shows the red printed pieces and the black original pieces that were copied.</p> Category: Electronics