(Solid fix) Walkera F210 Racing Drone Feet W/ Motor Guard

thingiverse

(Edit: v2 files use standard 16x19mm bolt spacing. they were shy 1.33mm and made bolts crooked. i should have measured them beforehand.) *Fixed the model mesh to make the files one solid model instead of two which causes print and structural issues. (bottom plate/guard was separate from foot structure) *Print time is reduced due to being one solid mesh. when i printed the original it broke into two pieces prying it off the print bed. I investigated to find out it wasn't properly modeled and op took short cuts to save time. it took ~10 minutes to fix both files. The overall result should prove to be better/stronger than the original. I do thank op for the model but recommend they use better modeling practices in the future.