Sonicmodell Binary servo mount (Ail/Ele/Rud) for Emax ES3302

thingiverse

These parts allow a clean installation if Emax ES3302 servos which I chose for my Binary build. Of course the parts might be of use for different planes. You need: - M2 screws (4mm lenght for Ele/Rud; 12mm length for Ail) - M2 nuts Make sure the screws pass through the bore holes without issue. If not, use a 2mm drill and carefully rework the part. Press the M2 nuts into the 3D-print. I used a drop of thin CA to secure it. The Ele/Rud mount should just snuggly fit into the Binary's wooden mounting plate. Use CA to fix it in place and allow it to completely dry before installing the servos. For the Ail mount, press the part into the foam, remove it, and cut the foam with a sharp knife along the marks this left behind. CA the part to the foam - again, allow it to fully cure.