Sony Xperia M4 holder

thingiverse

Just a very basic holder for Sony Xperia M4. Ment to be printed in PLA and Ninjaflex or similar soft plastic. The idea is to make the holder out of PLA and then print the 'sleeves' which will hold the phone with ninjaflex, to reduce vibrations and provide less harsh of a grip. The bracket is ment for a 1" / 25.5mm bar, commonly found on motorcycles. You can print thicker sleeves to adjust for smaller bars though. Hardware needed: 1x m4x30 3x m4x20 2x m4 nuts Check me out at: Youtube: http://www.youtube.com/c/MrCrankyfaceProjects Instagram: https://www.instagram.com/mr.crankyface/ 3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface Patreon: http://patreon.com/Mrcrankyface Print Settings Printer: Custom CoreXY Rafts: No Supports: No Resolution: 0.2 Infill: 20% Notes: None of this will need support if printed the right way up and you can probably go as low as 10% infill depending on your infill pattern.