Soporte sensor autonivel

thingiverse

Protein for Inductive Sensor for Autoleveling \n\n \n \n Instructions\n[Materiales]: Extruder Box\n1 Prepared inductive proximity sensor ready to install\n1 Protein sensor support\n[Instructions]\nInsert the proximity sensor into its protein support using the two nuts it comes with. One at the upper end and another at the lower end. Do not tighten the nut at the lower end yet. Observe how far the sensor protrudes from the bottom.\nAttach the sensor-support assembly to the extruder body on the right side of it, using the screw installed in the previous step. It is essential that the sensor be parallel to the tip of the hotend.\nTo connect the sensor, you will have a 2-pin Dupont connector (red and black cable) and an independent cable ready to directly connect to the 12V output of the power source, as indicated later.