Soup Can Pegboard Holder

thingiverse

This bracket allows you to attach a 86mm can to your quarter-inch pegboard via a 3x1 row of holes.. Makes a great pen/brush holder and prints qucikly without supports. All of the attachments here are done via friction, so I suggest printing with a rigid material. My cans stuffed with sharpies are staying put on my board but I wouldn't suggest going heavier. This was designed with two m2x10 slots on the back of the print to allow for screws to hold the can in place, but the can seems to stay put just fine without them. This is marked as a remix because it uses the same pegboard attachments as the attached model, slightly remixed to fit the holes more snugly than the originals.