SOUTH BEND LATHE MODEL 9C ( 1937-1940 ) HALF NUTS CAM LEVER

thingiverse

This is a replacement part for a South bend lathe model 9C that I just received, this part was missing so made a replacement out of ABS PLA may be stronger. I made it in 2 halves and glued them together with ABS juice. The photo's are some I found on the net, as I did not have one to copy. Works fine as there is not much load on the lever. I will have other pieces for this same lathe, change gears, cross slide nut, top slide handle, Plus whatever I need to replace because it is missing or worn out. My lathe was made between 1937 and 1940. Post-Printing clean up Depending on your printer will need minimal clean up on the dia that fits into the hole in the apron