Sovol silicone bed spring spacers.

thingiverse

After upgrading to silicone bed springs on my SV03 I found the bed height to be at the very end of the z travel so I made these spacers to bring the bed up some more. It’s simple. Print 4 of them then install under the silicone springs. Print in 100 percent infill as it needs to be stable. Higher temp materials always better but not required unless you’re using an heated enclosure. Not sure if this is needed for most people but on my printer the z height had almost 420mm of travel. So I had to make these spacers. I’d imagine they’d work on any printer with Silicone springs. I highly recommend the silicone springs. They make a big difference in adding stability to the print bed.