Sovol SV04 Runout Sensor Offset

thingiverse

First I want to thank the original designer, Jeritjax for this awesome bracket that I use on my 5 pluses. I shortened the original design to fit 2020 extrusions so it can be mounted on the top extrusion of the SV04 using M4x12 screws (you might need to add 2 washers). I'm using this to mount the filament runout sensors (2 M4x16 screws and nuts) to be in better alinement with the spools and extruders and lessen the amount of friction. I'm not sure if the hole alignment is 100% correct for the sensor mount. Feel free to mod as needed, it should be closer than the original that I printed. Printing: Sovol IDEX SV04 slicer default settings for 0.2 layer height, 60mm/s, 20% infill, no supports needed,