Spacehulk HVAC Turbo Lift Elevator

myminifactory

This is a modular elevator set for the Dragon's Rest HVAC Tunnel Kit, made completely by myself. Print and have fun! :Dhttps://dragons.rest/collections/sci-fi/products/hvac-tunnelsThe modular parts are compatible with the C-Kit and you can use the wall parts as general walls if you like, or swap parts to others in the Dragon's Rest lineup. You can even use my 2x3 custom floor with the C-Kit stuff. The floor is made so you can use LED lighting underneath and a small CR2032 is included. You only need a 3mm 3V LED bulb and the CR2032 battery. Tip 1: There are three floor bottom parts if you use the LED version. Each one has mounts scaled so when you scale it, the LED unit will always be the right size (it's the only part you can't scale, since the battery and LED are always the same size). I have made pre-scaled bottoms for 80, 100 and 135 percent scales. Scale the chosen bottom to that size, just like the rest of the stuff. Hope you figure it out. :DTip 2: If you just flip the battery so that negative side is downwards, you can store the battery there without it being on. And when you want it turned on, take it out and put in the right way.Tip 3: You might not want to glue in the top floor part. It will hold there when assembled quite well. Makes it easier to access if you use LED's.There is also two versions of the entrance module. The lower one you can use if you intend to build a custom multi-level Space Hulk map. There are clip holes you can use with magnets, so the carriage will then lock on the upper level with magnets.