Spacer for Screw Hole

thingiverse

I made these little spacers to fit between the bottom of my desk and the first hard drive holder slot. One of my hard drives (Seagate 4tb I think it's STGX4000400) is much larger than will fit in the slot in the project and instead of designing a whole new holder, I figured it was easier to just increase the space for the top slot. The file only contains one but obviously you'd need to print 4 to use for all four screws. The spacer is 6mm tall, outside diameter of the circle is 10mm inside diameter of the hole is 3.5mm. You could easily extend this in the Z dimension non-uniform to make a taller or shorter spacer or to widen the whole thing using XY. It isn't exactly a remix but it is an additional part to go with https://www.thingiverse.com/thing:398515