Spheres of Influence Box Insert w/ Magnets!

thingiverse

I did an older version of an insert for this game, but it needed so much improvement and I think this accomplishes that. Right around the time I sat down to design this, I saw an insert for Rallyman GT by LuckyDude78 that utilized 5mmx2mm magnets, and I liked the idea so much that I wanted to try it. Here are some notes: 1. My cards are in KMC Perfect Fit Sleeves, so that was my starting point with the design. The spots for all cards are all 93mmx67mm, so it is possible that other sleeved cards will fit. 2. You need to print (2) Filler Blocks 3. The Special Action Top and Bottom are the same exact file, i just put if on there twice for those that maybe have the need to check boxes to make sure they've printed everything. The design here is to allow the cards to be held, and then when they are separated you have a draw/discard holder. **The magnets that I used are strong enough that i can lift this out of the box and it stays together, I recommend testing this and keeping it in mind. 4. I exported the STLs straight from F360 and did not rotate, so all of the lid files will need to be rotated to lay flat 5. I tried to order the pictures in the order I would put them in the box. 6. Can be used for vertical storage if that is your preference 7. Warping will be an enemy here, so I recommend printing pretty much everything with a decent brim, and avoid using a heat gun/hair dryer for cleaning up any stringing.