Spice rack - numerous variants + parametric + source file

thingiverse

This design is made to fit most of Lidl and Tesco spice bottles. I can on request create different variants with different dimensions, by my default dimensions are **43_13_20** (notice the filename prefix): - **43mm** square hole for the bottle (small fillet on the corners) - **13mm** spacing on each side for you to be able to place fingers around the bottle when picking it up - **20mm** height of the whole rack, which feels to me good enough compromise between still being able to hold the bottles in place, while not wasting filament When I will be updating this model with more variants, I will keep the naming convention consistent with the above. Before printing check the image where I show what bottles do fit and check your dimensions on your bottles to make sure it will fit, if not request in the comments your dimensions, or open the source file and change the parameters. Additionally, the holes have 2 degree slope and making the top hole slightly bigger for easier insertion. My personal favorite is 3x3 as that's what I need while able to fit into my printer without issues. If you have small printer then feel free to print multiple ones and use double side tape (or glue) to put them together. There is outside fillet around the whole frame to make the acceleration forces smaller and easier for the first layer to stick. Overall I recommend printing it without support, 8% infill, 0.3mm layer height, 2 perimeters, and 2 top/bottom solid layers. On my printer these settings do not produce as strong models as using 3 for perimeters/top/bottom however this print doesn't have to be that strong and the filament savings do add up.