Splatoon Stinger (Salmon Run)

thingiverse

This is the Stinger from Splatoon 2 and 3 (duh). Important! All the pots will have a thin layer where the actual 3d models would sit on one another, as long as you don't repair the file when importing the slicing process will remove it. Update One! I have added a spacer for pot 5, the one below the stinger itself, as it tends to slip further into the pot than I want. The print settings are below. Base: Supports and Raft (be gentle when removing the supports) Pots 0-2: Supports and Raft Pots 3-5: Supports and Raft (the extruding bits on the outside may not print correctly, they are very delicate especially pot 4) Pot 6 and spacers: No Supports or Rafts Stinger itself: Supports and Raft (print at 45 degree angle leaning back to prevent the stinger nozzle from drooping/looking bad) Make sure to print 3 spacers for the bottom pots For gluing this together I used super glue (which wasn't the best idea) so I would recommended using a hot glue gun Hope you all enjoy!