Split in 2 pieces for shorter print beds (Remix Can Crusher Base)

thingiverse

I couldn't get the original version of this to fit in my printer, so I made it into two pieces with attachments. I also added holes for screws along the middle of the back, because I plan to mount it on a joist. They should fit a #8 wood screw. You'll need to turn the top piece upside down to print. Still need supports for the pin holes & screw holes. The middle screw hole goes through both pieces for added strength, but I still glued both pieces together to make sure it's as strong as possible. I realize there was another remix for shorter print beds, but I couldn't get it to print on an angle. Update 01FEB2022: This assembled fine, but the first time I went to use it, it broke in two parts. It didn't seem to break at the seam. I only used ~20% infill, whereas the original design suggested much higher. In hindsight, more infill would be good. Expecially in the thin rails at the front. Update 03APR2022: Added rev 1. I have not tried printing it yet, but used the same tolerances as the previous setup. Rev 1 design adds semi-circle to the front pieces for more strength. Also beef-ed up the joint on the front bars. If anyone prints this, let me know if it works!