Spool Spindle And Washers

thingiverse

Spool roller for standard width spools. It's fat but not fat enough to fully fit the spool hole, did this so it would spin freely. If this is going on a threader rod I would suggest to put the rod in a drill and run while holding spool holder and moving it back and forth just to clean out any burs and to help it spin freely. 10 - 15% infill should be plenty. If nuts are going against the spool washer what I would do is finger tighten the nut against the washer then move it back 1/4 of a turn. This will allow it to still move freely on the rod as well as allow the washers to spin independently from the spool holder itself. If you print this, please upload a pic to the "I Made One" tab. I love seeing my designs get printed :) Thanks! Print Settings Printer Brand: Prusa Printer: Prusa Clone Rafts: Doesn't Matter Supports: No Resolution: .2 Infill: 10 to 15%