Spoolbracket Upgrade (Anycubic Kobra)

thingiverse

UPDATE 07.08.2023 added two new parts (not tested yet!): endcap_duo_simplifiedx70mm (for “holder+20mm”) endcap_duo_simplifiedx90mm (for “holder”) these allow the spoolbracket to be mounted on the anycubic kobra plus aswell. See therefor: https://www.thingiverse.com/thing:5917626 ---------------------------------------------------------------------------------------------------------------- UPDATE 19.07.2023 added additional spoolbracket_+30mm_height which provides filament spools up to 255mm in diameter. ---------------------------------------------------------------------------------------------------------------- UPDATE 15.07.2023 recently added following parts: spoolbracket_+10mm_height endcap_duo_simplified_-10mm_length In case you have slightly larger and wider spools that won't fit with the original parts. “endcap_duo_simplified_-10mm_length” allows using the “holder+20mm.STL” from https://www.thingiverse.com/thing:5917626/files --------------------------------------------------------------------------------------------------------------- Upgraded spoolbrackets for the Anycubic Kobra, which provides the following: Spool is completly centered above the printer and turned by 90° new brackets are far less wobbly then the standard metal one spool can easily and quickly be removed from the printer max. spool diameter: 195mm Parts for Brackets:* 2x spoolbracket.stl 4x centering.stl if not using screws, i recommend to glue them into spoolbracket Parts for Spoolholders [2 Options]: Option 1: https://www.thingiverse.com/thing:5917626 dual-sided mounting variant Parts List: 2x bearingpart_1.stl 2x bearingpart_2_V2.stl 2x counterpart_1.stl 2x counterpart_2.stl 2x endcap_duo_anycubic_kobra.stl 1x holder.stl 2x clamp.stl 2x springdisc.stl 2x bearing 608-2RS 6x M3x16mm cylinderhead screw 6x M3 nut Option 2: Simplified Spoolholder Parts List: 1x holder.stl (from universal/modular spoolholder) 2x clamp.stl (from universal/modular spoolholder) 2x endcap_duo_simplified *Optional: 4x M5x40 cylinderhead - the brackets work fine without any screws, if you still prefer to screw it on top of the printer, the brackets are ready for this and just replace the original too short screws from the printer. (make sure, you also use the screw locks from the original printer mounting - these can be found under the 4 top screws from the printer) All parts were printed with 0.2mm layer height, 15% infill, 50mm/s, PLA 200°/60° and support, where needed. (no supports needed for the threads with theses parameters!) See slicerpictures for print - orientation.