Spray Paint Wand for Miniatures

thingiverse

A wand for holding gaming miniatures for spray painting. Ideal for applying primer, base coat, or clear coat. Modular design make the platform extendable. Be sure to print the base platform upside down, with prongs facing up. This will allow for minimal supports and give you a flat surface to place your miniatures on. After printing, parts should fit together tightly. Be aware that ends may require a small amount of sanding for a close fit. A small amount of glue may be used for a permanent hold. Once assembled, stretch small rubber bands from one hook, across the platform, to the hooks on the other side. Once in place, you may slip the base of your miniature between or under the rubber bands to hold it securely for spray painting. Should be large enough to hold most common sizes of gaming miniature bases. If a longer platform is desired, you may print a second platform, and use the included hex pin to connect them together. If you prefer a longer shaft, extensions may be used to create more distance between the handle and the platform. Please note that the one shown in the photos is of an early design, and some features were modified or added before upload (extension, pin, longer handle). Please refer to Thingiview.